Stainless Steel Narrow Doorbell 1" x 3" with LED Button (Green Dot LED)

Solid stainless steel doorbell cover plate, 3/16" thick, with a brushed finish. The "Narrow" doorbell is a slim 1" width profile that fits on almost any doorjamb, or tight spot. Illuminated LED push button uses less than 1 watt, and should last over 10 years. LED buttons available in Ring-Light, or DOT style. Ring Light has a bright glowing ring around a stainless steel center. DOT Light has a very bright center LED glow. Doorbell Buttons are theft-resistant. Each button is secured on the back of the doorbell cover by a hex-nut. Will work with new or existing doorbell systems, and can replace most garage door opener buttons. Doorbell Only. Door chimes, power transformers, and wire not included. Warranty Information: 90 day warranty against defect. Product Specifications: The Narrow Doorbell Cover Measurements: 1" Wide x 3" High x 3/16" Thick. Push Button Measurements: RING and DOT Light LED Buttons: @ 5/8"W x 1 3/4"L. Non-Lit Buttons: 5/8"W x 7/8"L. Push Buttons are LOW VOLTAGE (12-24 Volts AC). Exceeding the button's voltage can prematurely burn out the LED in the button. Installation: Installation Instructions: Attach the doorbell button to the stainless steel doorbell cover using the provided hex-nut. Drill a 3/4" (20mm) wide hole into doorjamb (or surface for doorbell) approximately 1 1/2" deep for RING or DOT Light buttons, 1" deep for Non-Lit buttons. Attach one wire to each screw terminal, which wire going to which screw terminal doesn't matter. Use the provided screws to mount the doorbell cover in place.

• Stainles Steel Doorbell cover, 316 Grade Stainless, 3/16" Thick
• Narrow Doorbell: 1" x 3" plate size
• LED or Non-Lit Doorbell Buttons
• Replaces any basic doorbell button or garage door button
• Includes Stainless Steel Doorbell Cover, Door Bell Button, Mounting Screws